ADS1292ECG-FE: ADS1292ECG-FE

Arthur Jacquemart

Part Number: ADS1292ECG-FE
Other Parts Discussed in Thread: ADS1292

Hello,

I have an issue with this evaluation board. I can only display lead II. The other vectors are in gray and thus can not be selected...

I did not find any topic about that problem, do you know the source of the problem?

Thank you for your time,

Arthur.

over 8 years ago

0 Rachel Liao over 8 years ago

TI__Expert 6480 points

Hi Arthur,

I've moved this question to the appropriate forum: e2e.ti.com/.../73

Thanks,
Rachel

0 Tom Hendrick over 8 years ago

TI__Guru**** 180941 points

Hi Arthur!

Welcome to our e2e forum! If you take a look at the schematic for the ADS1292ECG-FE (in the back of the Users Guide) you can see that IN2N comes from P5.1 which we call ERA (ECG Right Arm) and that IN2P comes from P5.3 which we call ELL (ECG Left Leg). In classical ECG, RA(-) -> LL(+) is defined as Lead II, which is why the software is setup the way it is.

0 Arthur Jacquemart over 8 years ago in reply to Tom Hendrick

Prodigy 40 points

Thank you for your answer.
If I understood well, it is impossible with this software to display an other lead, is that it?

thanks for you time,
Arthur

0 Tom Hendrick over 8 years ago in reply to Arthur Jacquemart

TI__Guru**** 180941 points

That is correct, at least for the ADS1292. We use the same GUI with the ADS1298ECG-FE which has additional channels and in that case, the other grey LEAD options are available.

0 Arthur Jacquemart over 8 years ago in reply to Tom Hendrick

Prodigy 40 points

Ok thank you very much for your fast answer.

Best regards,
Arthur.

Data converters

Data converters forum

ADS1292ECG-FE: ADS1292ECG-FE