ADS6142: about Default value of the register

Tsukui Yusuke

Guru 21930 points

Part Number: ADS6142

Hi,

Could you tell me default value of SERIAL REGISTER?
It was not listed in a datasheet.

Best Regards,
Yusuke/Japan Disty

over 9 years ago

0 Richard Prentice over 9 years ago

TI__Mastermind 29220 points

Hi,

I've asked the design team about this.

Regards,

Richard P.

0 Tsukui Yusuke over 9 years ago in reply to Richard Prentice

Guru 21930 points

Hi,

Can I get the information?
Customers need that information for design.
If you need more information or if I should clarify my comment ,
please let me know.

Best Regards,
Yusuke/Japan Disty

0 Richard Prentice over 9 years ago in reply to Tsukui Yusuke

TI__Mastermind 29220 points

Hi,

I have not yet gotten the information from the design team so I have reminded them again that we need this information.

Regards,

Richard P.

0 Tsukui Yusuke over 9 years ago in reply to Richard Prentice

Guru 21930 points

Hi,

Can I get the information?
Customers need that information for design.
If you need more information or if I should clarify my comment ,
please let me know.

Best Regards,
Yusuke/Japan Disty

0 Richard Prentice over 9 years ago in reply to Tsukui Yusuke

TI__Mastermind 29220 points

Hi,

in most of our older devices like this, the default value for the SPI registers after reset is usually zero. I have not seen any registers that are not default zero on these older devices, but I have not gotten confirmation from the design team on this so my confidence level on this statement is maybe 90% confident, rather than 100% confident in that answer.

Regards,

Richard P.

Data converters

Data converters forum

ADS6142: about Default value of the register