TSW14J56EVM: Error message with test setup

Dillon Waters

Part Number: TSW14J56EVM
Other Parts Discussed in Thread: LMK04828

Hi I am using the TSW14j56EVM board along with the TSW38j84EVM board. I am following the test setup described in the TSW38j84EVM user manual. When I got to step 6 i.e. clicking the send button onthe HSDC pro GUI. I keep getting a message prompt show below. How do I solve this. I can see anywhere to configure the JESD reference clock. I will also show some photos of my GUI setup.

over 9 years ago

0 jim s over 9 years ago

TI__Guru* 91947 points

Dillon,

What are you trying to solve? The window is just telling you what the reference clock rate is required by the FPGA on the TSW14J56EVM. The GUI automatically provides the correct divider to the LMK04828 on the TSW38J84EVM, which is the part sending this clock to the FPGA.

Regards,

Jim

0 Dillon Waters over 9 years ago in reply to jim s

Prodigy 240 points

I thought this was an error? Is the data being sent when this message appears?

0 jim s over 9 years ago in reply to Dillon Waters

TI__Guru* 91947 points

This is not an error, just a message. The data is sent after you click on the send button.

Data converters

Data converters forum

TSW14J56EVM: Error message with test setup