Other Parts Discussed in Thread: DAC38RF82EVM
Hello, I have been trying to setup the TSW14J56 pattern generator board to support a DAC38RF82EVM board. When I get to the point of downloading the fpga firmware in HSDCP, it always errors out with the below message:
Error 1097 occurred at Call Library Function Node in TSW1400.lvlib:14J56revD_Firmware Details.vi->TSW1400.lvlib: Frame.vi
Possible reason(s):
LabVIEW: An exception occurred within the external code called by a Call Library Function Node. The exception might have corrupted the LabVIEW memory. Save any work to a new location and restart LabVIEW
So far I have followed the instructions in the DAC38 eval board manual to the best of my ability and configuration in the DAC38RF8xEVM GUI goes smoothly. All of the jumpers and switches should be in the correct default positions and the power supplies all seem to be operating fine.
Is there a potentially obvious solution to this error message that I am missing?
Side notes:
I do not have much experience with labview, but should a TSW1400.lvlib file exist in the HSDCP installation? Also, the TSW14J56 board I have is revision E, yet all the software and released schematics seem to be for revision D. Could that discrepancy cause an issue?
