ADS42LB69EVM: Interposer Card between ADS42LB69EVM and Altera Developement kit through FMC

Vijetha,

Thanks for the suggestion.

Regards,

Jim

Hi,

Please suggest suitable Interposer card details.

Vijetha

Vijetha,

I do not have the schematic of the FPGA board you plan on using but the only thing TI offers is the FMC-ADC-Adapter board that can be found on the TI website using the link below. Even though the description has Xilinx in the title, this may work for you. What I noticed is that the P/N of the data outputs are swapped on the adapter HSMC connector. You need to verify this against your Altera schematic to see if the swap still exists and that the firmware can un-swap the data. The adapter schematic is attached.

Regards,

Jim

7673.FMC-DAC-ADAPTER_D_SCH.pdf  

  

Thank you for valuable suggestions.

I will check on pin compatibilities between FMC pin out of the FMC-ADC adapter and FMC pin out of our Dev.Kit.

Meanwhile can you please confirm on the Mating of the Samtec connectors used in Adapter vs ADC EVM? I found that QSH-30-01-D-03-A is used in FMC Adapter and QTH-060-01-F-D-A-RT1 is used in ADC EVM. Whether they will mate each other and are they pin compatible to each other? Please confirm.

Regards,

Vijetha

 

Hi,

I got schematics of the Dev Kit, available in below link:
www.altera.com/.../a10_soc_devkit_03_31_2016.pdf

And the FMC connectors used in the Dev Kit is 400 pin FMC (High pin count) but the FMC connector used in FMC-Adapter Card is just 160 pin FMC.
By looking into the Dev Kit schematics can you check and find out whether there is any Adapter card to ue between ADV EVM and Altera Dev Kit?

Regards,
Vijetha