Other Parts Discussed in Thread: ADS1015
Hi team,
I am considering to use ADS1015-Q1's I2C communication with MCU over Serializer and Deserializer as below.
ADS1015-Q1 <--> Deserializer <- Cable(I2C signal embedded into serial signal) -> Serializer <--> MCU
There is maximum 40us delay from ADS1015 to MCU, and I am concerned if ACK by Master(MCU) delays 40us after Data output from ADS1015.
Refer to datasheet page 20 Figure15
Is there any requirement between end of ADS1015 data out to ACK by Master timing?
regards,