HSDC Pro

user6360432

Other Parts Discussed in Thread: ADC32RF80EVM

when i save a .csv file from the HSDC Pro of a frequency domaim siginal captured from a ADC,how can i open it? when i open it with the HSDC pro, i can't get the frequency domaim siginal, just can see some codes.

over 5 years ago

0 jim s over 5 years ago

TI__Guru* 91947 points

User,

You must enter a valid ADC output data rate value in the lower left of the GUI to see the frequency domain data.

Regards,

Jim

0 user6360432 over 5 years ago in reply to jim s

Intellectual 320 points

hello,

JIm

when I disconnect the board to my pc, and open the .CSV file saved by HSDC pro, set the correct ADC output data rate which is consistent with which I connect the board, but I can't find my sampleing data. as the picture below, I sampled 60MHz frequency, but when I save it as .CSV file,and open it after disconnect the board, the result is different. Why?

0 jim s over 5 years ago in reply to user6360432

TI__Guru* 91947 points

User,

When you select "Import Binary File" are you entering the correct parameters in the new window that opens that asks for "Number of Channels" and "Number of Bits"?

Regards,

Jim

0 user6360432 over 5 years ago in reply to jim s

Intellectual 320 points

I am not sure what is "Number of Bits", when I use ADC32RF80EVM, decimation is 4X, DDC mode, what is "Number of Bits"?

0 Vijayendra Varma Siddamsetty over 5 years ago in reply to user6360432

TI__Genius 10995 points

Hi User,

"Number of bits" in this mode is 16.

Regards,

Vijay

Data converters

Data converters forum

HSDC Pro