TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    ADS1256: ADS1256 keep showing 0 value on the Arduino serial monitor 0

    35 views
    1 reply
    Latest 4 days ago
    by Keith Nicholas
  • Answered

    ADC3669EVM: Rev A Design Files 0

    310 views
    17 replies
    Latest 4 days ago
    by Luke Allen
  • Not Answered

    ADS61B49: ENABLE LOW SPEED MODE 0

    41 views
    2 replies
    Latest 4 days ago
    by ttd
  • Suggested Answer

    ADS131B26-Q1: ADS131B26-Q1 GPIO trigger ADC sampling 0

    33 views
    1 reply
    Latest 5 days ago
    by Joachim Wuerker
  • Suggested Answer

    AMC1336: Jitter Requirements for AMC 1336 0

    31 views
    1 reply
    Latest 5 days ago
    by Tom Hendrick
  • Not Answered

    ADS112C04: ADS112C04 with two RTDs 0

    66 views
    3 replies
    Latest 5 days ago
    by Andrew Kalthoff
  • Not Answered

    DAC161P997: If output current increases above about 23ma, the output suddenly drops to about 0 ma. Is there an alternative that doesn't do this? 0

    42 views
    1 reply
    Latest 5 days ago
    by Joseph Wu
  • Not Answered

    DAC80501: Abnormal output voltage if MSB changed... 0

    228 views
    13 replies
    Latest 5 days ago
    by Erin Bowrie
  • Answered

    DAC7634: Output amplitude from +/-5V to +/-10V 0

    41 views
    1 reply
    Latest 5 days ago
    by Joseph Wu
  • Answered

    TSW12QJ1600EVM: Maximum number of received lanes (number_of_RX_lanes) in TI-JESD204-IP 0

    41 views
    1 reply
    Latest 5 days ago
    by Rob Reeder
  • Answered

    DAC39RF10: Spurious and harmonic at Fs/2, Fs, and 1–2 GHz (Fs = 1 G / 2 G / 3 G) 0

    88 views
    1 reply
    Latest 5 days ago
    by Rob Reeder
  • Suggested Answer

    ADC3564: Clarification on ADC3564 Configuration and Datasheet Inconsistencies 0

    242 views
    13 replies
    Latest 5 days ago
    by Luke Allen
  • Answered

    ADS7028: Unable to get ADS7028 working in Autonomous mode. 0

    113 views
    6 replies
    Latest 5 days ago
    by Ramesh Chhetri
  • Not Answered

    DAC5672A: Interleaved mode access 0

    20 views
    0 replies
    Started 5 days ago
    by Gil Hershman71
  • Not Answered

    ADC34RF72EVM: Request for ADC34RF72EVM Hardware Data 0

    65 views
    2 replies
    Latest 6 days ago
    by seungpum kang
  • Suggested Answer

    ADS7950: ADS7950SBRGET 0

    148 views
    7 replies
    Latest 6 days ago
    by Joel Meraz
  • Answered

    ADS7952: How to select channels in manual mode? 0

    53 views
    1 reply
    Latest 6 days ago
    by Joel Meraz
  • Suggested Answer

    ADS1258-EP: On the ADS1258, what specifically occurs when the SPI Interface resets? 0

    25 views
    1 reply
    Latest 6 days ago
    by Keith Nicholas
  • Answered

    DAC8742H: Burst command, HART 0

    38 views
    1 reply
    Latest 6 days ago
    by Joseph Wu
  • Suggested Answer

    AMC1035-Q1: Dependency of 2.5V on CLK signal 0

    31 views
    1 reply
    Latest 6 days ago
    by Keith Nicholas
<>