TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    DAC81416EVM: Initial value of the STATUS register 0 Locked

    206 views
    1 reply
    Latest over 6 years ago
    by Uttam Sahu
  • Suggested Answer

    DAC38J84: Configuration of SERDES lines for quad channel conversion at 1228.2 MSPS 0 Locked

    513 views
    1 reply
    Latest over 6 years ago
    by Kang Hsia
  • Answered

    TSW1400EVM: Instruction for testing a TSW1400 EVM with an ADS5484 EVM 0 Locked

    892 views
    4 replies
    Latest over 6 years ago
    by THINH LE
  • Suggested Answer

    ADS42B49: How to design driver circuit using amplifier 0 Locked

    828 views
    5 replies
    Latest over 6 years ago
    by Lu Wong
  • Suggested Answer

    ADS1298: Input Differential Dynamic Range 0 Locked

    970 views
    1 reply
    Latest over 6 years ago
    by Ryan Andrews
  • Suggested Answer

    AFE7225EVM: Software and Connectivity/Interfacing. 0 Locked

    360 views
    2 replies
    Latest over 6 years ago
    by Yusuf%20Agoro
  • Answered

    AFE5818EVM: AFE5818EVM 0 Locked

    425 views
    3 replies
    Latest over 6 years ago
    by Chen Kung
  • Suggested Answer

    TSC2004: ESD damage 0 Locked

    378 views
    5 replies
    Latest over 6 years ago
    by Collin Wells
  • Answered

    DDC114: Anti-aliasing Filter 0 Locked

    778 views
    5 replies
    Latest over 6 years ago
    by Mitchell
  • Suggested Answer

    ADS1261: Definitions of "Effective Resolution" and " Noise-Free Resolution" 0 Locked

    433 views
    1 reply
    Latest over 6 years ago
    by Collin Wells
  • Suggested Answer

    ADS1298: Page 12, Figure 9 R1, R2, R3 User's Guide Clarification 0 Locked

    301 views
    3 replies
    Latest over 6 years ago
    by Alexander Smith
  • Suggested Answer

    ADS1299: ADS1299 0 Locked

    244 views
    1 reply
    Latest over 6 years ago
    by Alexander Smith
  • Suggested Answer

    ADS1282-SP: Bias Current 0 Locked

    302 views
    1 reply
    Latest over 6 years ago
    by Christian Yots
  • Suggested Answer

    DAC161S997: 4-20mA current output (DAC161S997) and digital output (16-30V) share the same two terminals, which output mode selected leave to user, any ideas or solution available? 0 Locked

    567 views
    6 replies
    Latest over 6 years ago
    by Garrett Satterfield
  • Suggested Answer

    AFE7225: AFE7225 software tool "AFE722X EVM Software Control" 0 Locked

    794 views
    9 replies
    Latest over 6 years ago
    by dBrock
  • Answered

    DAC43608: how to configure unused pin 0 Locked

    290 views
    2 replies
    Latest over 6 years ago
    by Shinichi Inoue
  • Answered

    ADS131E08: Relation of input range vs. AVDD 0 Locked

    621 views
    4 replies
    Latest over 6 years ago
    by Shota Mago
  • Answered

    DAC37J82: how to config the parameters for DAC37J82 0 Locked

    506 views
    3 replies
    Latest over 6 years ago
    by Shai Berman
  • Answered

    DDC112: The problem of Download link of DDC11XEVM-PDK Plugin Installation 0 Locked

    292 views
    1 reply
    Latest over 6 years ago
    by Praveen Aroul
  • Suggested Answer

    ADS1298: ADS1298 IC alternative 0 Locked

    645 views
    3 replies
    Latest over 6 years ago
    by Collin Wells
<>