TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS1118 SPI Timing Requirements and Configuration Issues 0 Locked

    2826 views
    4 replies
    Latest over 8 years ago
    by Onur YILDIZ
  • Answered

    ADS1015: Config register not changing when being written to 0 Locked

    1293 views
    2 replies
    Latest over 8 years ago
    by Tom Eaton
  • Not Answered

    AFE4300EVM-PDK for the no data question 0 Locked

    901 views
    2 replies
    Latest over 8 years ago
    by Mickey Zhang
  • Answered

    DAC3174: DAC3174 0 Locked

    6081 views
    15 replies
    Latest over 8 years ago
    by Vikas Kumar40
  • Suggested Answer

    ADS8688EVM-PDK: Some problem on the ADS868X EVM GUI 0 Locked

    1331 views
    5 replies
    Latest over 8 years ago
    by Dale Li
  • Not Answered

    TINA/Spice/AMC1301: Why the output voltage will have such a huge value when the input voltage is zero ? 0 Locked

    2719 views
    6 replies
    Latest over 8 years ago
    by James Zhan
  • Answered

    TLV1578: TLV1578 alternatives 0 Locked

    687 views
    2 replies
    Latest over 8 years ago
    by Vishy Viswanathan
  • Answered

    ADS131A02: Noise and internal reference query 0 Locked

    681 views
    2 replies
    Latest over 8 years ago
    by Rohit J
  • Answered

    ADS122U04EVM: Error in EVM BOM 0 Locked

    904 views
    2 replies
    Latest over 8 years ago
    by Doug Labun
  • Not Answered

    PGA411-Q1: The power supply design guide 0 Locked

    804 views
    2 replies
    Latest over 8 years ago
    by Clancy Soehren
  • Not Answered

    PGA411Q1EVM: A few issues 0 Locked

    1075 views
    4 replies
    Latest over 8 years ago
    by Clancy Soehren
  • Answered

    ADS54J60: ADS54J60 IBIS 0 Locked

    594 views
    1 reply
    Latest over 8 years ago
    by high speed guy
  • Suggested Answer

    ADC12D1600RF: Resistor on Rtrin & Rext 0 Locked

    577 views
    1 reply
    Latest over 8 years ago
    by Jim Brinkhurst1
  • Suggested Answer

    DAC8822: VIhmin of digital datalines 0 Locked

    793 views
    3 replies
    Latest over 8 years ago
    by Paul_Frost
  • Suggested Answer

    DAC3174: Test plan using Altera Arria10 SoC Evaluation Board 0 Locked

    4789 views
    11 replies
    Latest over 8 years ago
    by Richard Prentice
  • Suggested Answer

    ADS5287: Why it can't output always 0 constantly in SINGLE_CUSTOM_PAT test mode 0 Locked

    1194 views
    4 replies
    Latest over 8 years ago
    by Richard Prentice
  • Suggested Answer

    ADS131A04EVM: starting conversion 0 Locked

    2438 views
    7 replies
    Latest over 8 years ago
    by Daniel Carelli
  • Answered

    ADC128D818: 12bits output data format of "16bits I2C output data", it is the high 12bits (bit[15]..bit[5]) or low 12bits (bit[11]..bit[0]) ? 0 Locked

    996 views
    4 replies
    Latest over 8 years ago
    by Iven Xu
  • Answered

    No voltage is applied to the sub(-50v) on the TX-SDK-V2 / NOPB board 0 Locked

    1238 views
    2 replies
    Latest over 8 years ago
    by Mintack Oh
  • Suggested Answer

    ADS54J60EVM: can We use xilinx EVM board? 0 Locked

    912 views
    1 reply
    Latest over 8 years ago
    by jim s
<>