How to write the load stripe to the cache and make it run by default

Qi Liu

Expert 5815 points

Hi, support team

How to use demo to load stripes into the cache?

I don't want to load stripes every time when I open the software

Best regards,
Yuki

over 4 years ago

0 SHIVAKUMAR R over 4 years ago

TI__Expert 3040 points

Hi Yuki,

I guess you are asking about storing the pattern images in flash memory to avoid loading the patterns images every time in "Pattern on the fly" mode.

If above is your question, Then the answer is using "Pre-Stored pattern mode". In "Pre-Stored pattern mode", we can display the pattern images stored in the flash memory. For this we need to first store the Pattern images in the Firmware, upload it to the LightCrafter system and display it in "Pre-Stored pattern mode".

LightCrafter User guide https://www.ti.com/lit/pdf/dlpu028 ,Section "3.6 Pattern Modes" explains about Pre-Stored pattern mode. User guide also explains about procedure to include pattern images in the Firmware and upload to LightCrafter system.

Below introduction videos will be helpful to understand features of LightCrafter EVM.
Getting started: TI DLP® LightCrafter 6500 and 9000 EVMs
https://www.youtube.com/watch?v=1BiGh6Gv-dY
https://www.youtube.com/watch?v=fYAXy2jwGeg
https://www.youtube.com/watch?v=0OYpDOSgqBc

Thanks,
Shivakumar

DLP®︎ products

DLP products forum

How to write the load stripe to the cache and make it run by default