DLPC230-Q1: How to modify the default brightness？

Li Zhao

Part Number: DLPC230-Q1
Other Parts Discussed in Thread: TPS99000

Hi, Our optomechanical system uses DLPC230+TPS99000 chips. We hope that when the optical system is powered on, the PGU output brightness is not the default maximum brightness, can you tell me how to operate to achieve this purpose?

over 2 years ago

0 Tristan Bottone over 2 years ago

TI__Intellectual 1750 points

Hello Li Zhao,

Thanks for reaching out and using the E2E forums. An expert from our team will review the thread and get back to you shortly.

0 Ross S. over 2 years ago in reply to Tristan Bottone

TI__Expert 4080 points

Hello Li Zhao -

There are two ways to set the default brightness. One is inside the "Auto-calibration" tool under the "Globals" tab.

The second is in Composer on the "Batch Command Sets" page, navigate to the "Command Set 0" under the "Auto-init" section:

Regards,

Ross

0 Li Zhao over 2 years ago in reply to Ross S.

Prodigy 120 points

I get it! Thank you very much!

0 Ross S. over 2 years ago in reply to Li Zhao

TI__Expert 4080 points

You're welcome, happy to help!

DLP®︎ products

DLP products forum

DLPC230-Q1: How to modify the default brightness？