DLPA2000: What is the LED current spike on the VLED line?

TH Chang

Prodigy 30 points

Part Number: DLPA2000
Other Parts Discussed in Thread: DLPC3435, DLPC3430, DLPC3433, DLPC3432, DLPC3438

Hi,

When measuring power consumption, I put a current probe on the green VLED line.(LED red/blue are turned off)

This is what I get:

What is the 760mA peak in red rectangle? Is it something like transient current?

Thanks.

T.H.

9 months ago

0 Maxine Cabrasawan 9 months ago

TI__Expert 3905 points

Hello T.H.,

Welcome back to the E2E forum. Thank you for your continued business!

Your image does display a transient current spike on your green LED. Transient current limit is set as one value for all three LEDs and cannot be customized between colors. Your overshoot amount can vary per color but the overshoot seen in your image is expected.

Best,

Maxine

0 TH Chang 9 months ago in reply to Maxine Cabrasawan

Prodigy 30 points

Hi Maxine,

Thanks for your reply.

I see a register on dlpa2000 on the datasheet which can set the transient current limit.

Is it possible to set the register through dlpc3430 I2C interface? (reference dlpu020e.pdf "DLPC3430, DLPC3432, DLPC3433, DLPC3435 and
DLPC3438 Software Programmer's Guide")

Best,

T.H.

0 Maxine Cabrasawan 9 months ago in reply to TH Chang

TI__Expert 3905 points

[deleted]

0 TH Chang 9 months ago in reply to Maxine Cabrasawan

Prodigy 30 points

Hi Maxine,

according to this document.

https://www.ti.com/lit/ug/dlpu020e/dlpu020e.pdf

Which command should I use to customize the register on dlpa2000?

Thanks,

T.H.

+1 Maxine Cabrasawan 9 months ago in reply to Maxine Cabrasawan

TI__Expert 3905 points

Hello T.H.

Yes, the register can be accessed by I2C. EDIT: I apologize, I did not clarify enough. This change requires a new firmware image once the change has been made. The guide you attached will not be sufficient to enable the change. Please send me a friend request to discuss this further. Thank you.

Best,

Maxine

DLP®︎ products

DLP products forum

DLPA2000: What is the LED current spike on the VLED line?