• State
  • Locked Locked
  • Replies 2 replies
  • Subscribers 28 subscribers
  • Views 462 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LightCrafter Pattern Sequence Upload image display Command Failed

GuoMin Zhan
Prodigy 100 points

Hi，As the subject，

My LightCrafter Firmware has update to 

DM365 Software version 4.0

MSP430 Firmware version 2.7

FPGA Firmware version 2.6.43

GUI Version 4.0.1:

When upload  Pattern Sequence as guide ，It says Command Failed.

Forgive my poor English.THX

  • 0
    TI__Expert 4500 points

    Hi GuoMin Zhan,

    Welcome to TI E2E Community!

    Command Failed Error could occur for following reasons,

    1. The image resolution should be 608x684 and 'Pattern Count' should be set correctly.

    2. New features have been added in DM365 v3.31 and above. One of these features - "Extended Pattern Sequence mode" require R205 (zero ohm) installed. This resistor is located on the systems board below the DM365. Can you double check both and let us know?

    Regards,

    Divya

  • 0 in reply to Divya Reddy
    Prodigy 100 points

    Thank you，my  resolution isn't correct.It works well now.