Version 1.0 needed

Takeshi Yuasa

Other Parts Discussed in Thread: DLPC350

Hello

Since the NIRscan somehow does not work correctly after I updated to version2.0, would you please give me version 1.0 of MicroSD image and DLPC350?

I can browse and run scan, but no scanning from 1900nm and longer, further every scan result is quite different. In parallel, I will re-update those files.

Regards,

Takeshi

over 10 years ago

0 Takeshi Yuasa over 10 years ago

Expert 1230 points

Hello

I succeeded to upgraded 2.0 and working well. Therefore please close this. It seems the first download file for MicroSD was corrupted.

Thanks,
Takeshi

0 Yaa Hussain over 10 years ago in reply to Takeshi Yuasa

Prodigy 175 points

Hello Takeshi. How to upgrade from version 1.0 to version 2.0? Do we need to download DLP NIRscan MicroSD Image for Windows 2.0 from www.ti.com/.../dlpnirscanevm only?

0 Takeshi Yuasa over 10 years ago in reply to Yaa Hussain

Expert 1230 points

Hello Hussain

You should download both NIRscan firmware Version 2.0 from that URL and also for DLPC350. These version should be the same.

Please look and find the install section in the user guide of NIRscan (from P35: appendix C) for detail instruction.

www.ti.com/.../dlpu016b.pdf

If you see some trouble after upgrading both firmware, maybe the download files are corrupt. Please download it and retry to make sure.

Takeshi Yuasa

DLP®︎ products

DLP products forum

Version 1.0 needed