I2C0 Master mode

Takeshi Yuasa

Other Parts Discussed in Thread: DLPC350

Hello,

In some description of this forum, you will have plan to support DLPC350 as an I2C master. If you have already supported, would you please let us know how we can use? (i.e. if we connect some I2C slave on I2C0 bus, how we can control I2C slave via DLPC350?)

Takeshi

over 10 years ago

0 Sanjeev over 10 years ago

TI__Mastermind 30875 points

Hello Takeshi-san,

We have found that the I2C0 master is not usable with both firmware revisions that are put on the TI website i.e., v1.1 and v2.0. So you will have to wait until we release 3.0 package - F/W 3.0 & GUI toll 3.0 with updated programmer's guide.

Regards,

Sanjeev

0 Takeshi Yuasa over 10 years ago in reply to Sanjeev

Expert 1230 points

Sanjeev-san,

Would you please let us know your schedule of releasing Master I2C?

Regards,
Takeshi

0 Sanjeev over 10 years ago in reply to Takeshi Yuasa

TI__Mastermind 30875 points

Hello Takeshi-san,

It is in ready for internal DVT cycle. We will update to you once we are ready for public release.

Regards,
Sanjeev

DLP®︎ products

DLP products forum

I2C0 Master mode