DLPC350 Pattern Sequence Vsync mode

Hi Hamada,

Could you also provide your settings from the trigger controls tab? I'll investigate if there are other reasons for your observed behavior.

Thanks,
Clinton

Hi, Clinton.

Thank you for reply.

Sorry for my late reply.

It was to capture the trigger controls tab screen.

Best Regards,

hamada

Hi, Clinton.

How about that?

We will wait for the reply.

Best Regards,
hamada

Hi, Clinton.

This matter, how about you ?
You will not get the reply?

Best Regards,
hamada

Hi Hamada,

Thanks for posting your trigger settings. Could you try setting the output trigger to no delay (value of 187) and see if the results are the same?

Thanks,
Clinton

Hi, Clinton.

Thank you for reply.

I was set to output trigger = 187 (no delay).

I will attach the waveform.

There were no changes in Pattern Expose and Pattern Period.

What do you think of the specification of FW3.0?

Best Regards,

hamada

Hi Hamada-san,

It is also same issue as described in your other thread https://e2e.ti.com/support/dlp__mems_micro-electro-mechanical_systems/f/924/p/492487/1839017#1839017 We will get back to you on this.

Regards,

Sanjeev

Hi, Sanjeev.

Thank you for reply.

I will confirm the contents of another thread.


In the case of here,
Do you have a plan of an update of firmware?

Best Regards,
hamada