DLPDLCR2010EVM: DLPDLCR2010EVM

Jackie Sharp

Part Number: DLPDLCR2010EVM

Hello,

On a lot of your bill of materials there is an HDMI chip called IT6801FN... however this is no where to be found on the internet or their respective data sheet. Is there anywhere to acquire this? Are there any alternative chips from FTDI or other manufacturers.

Thanks,

J. Sharp

over 6 years ago

0 Brandon Seiser over 6 years ago

TI__Intellectual 1825 points

Hi Jackie,

Thank you very much for your question and interest in our DLPDLCR2010EVM! The chip you are referencing (IT6801FN) is an HDMI receiver from ITE. I have included a link in this post so you can learn more about this product.

http://www.ite.com.tw/en/product/view?mid=51

Please let us know if you have any further questions!

Thanks,

Brandon

0 Jackie Sharp over 6 years ago in reply to Brandon Seiser

Prodigy 190 points

Hi Brandon,

Sorry to bother you! We are looking for the pinout of the chip... or even where to source it! We are using one of your eval boards and wanted to make a supplemental board and wanted to know the pinout/signal information about the product... however there is no information to be found!

Are there any engineers by chance that have notes on the product?

-Jackie Sharp

0 Brandon Seiser over 6 years ago in reply to Jackie Sharp

TI__Intellectual 1825 points

Hi Jackie,

We are always here to help you! It appears that ITE has not made the datasheet public for this product, as it is not on their product page (the link in my previous response). Have you tried reaching out to ITE directly or to a distributor requesting this product? I believe these avenues will be the best bet for finding this information.

As for a supplemental board, did you know that we have published the design files with the EVM? This allows you to get the extra same PCB made that is in the EVM. This page: http://www.ti.com/tool/TIDA-00325 has all of that information on it.

I will check with our team to see if there is any additional information we can share about this product.

Thanks,

Brandon

0 Brandon Seiser over 6 years ago in reply to Brandon Seiser

TI__Intellectual 1825 points

Hi Jackie,

Please accept my friend request. Once you have accepted, I will follow up off-line.

Thanks,

Brandon

0 Jackie Sharp over 6 years ago in reply to Brandon Seiser

Prodigy 190 points

Hi Brandon,

I accepted the request.

-Jackie

0 Brandon Seiser over 6 years ago in reply to Jackie Sharp

TI__Intellectual 1825 points

Hi Jackie,

I just sent you a message.

Thanks,

Brandon

DLP®︎ products

DLP products forum

DLPDLCR2010EVM: DLPDLCR2010EVM