SN65HVD230Q: Running at half baud rate

Brandon Van Pelt

Part Number: SN65HVD230Q

My rapid prototype was a ESP32 development board and VP230 module I purchased off Amazon that works correctly (pictured on left). Everything works correctly on my board (pictured on right) except the speed is half. 1000k baud runs at 500k baud, 500k baud runs at 250k baud, etc.

I am using the SN65HVD230Q purchased from LCSC.com. Here is my schematic:

I am using the public esp32_can library and a library software bug is not ruled out but is there anything in hardware that I should consider or debug that might be causing this issue?

over 2 years ago

0 Clemens Ladisch over 2 years ago

Guru 286060 points

This transceiver works at the electrical level; the bus state follows the voltage at the D pin. The problem must be somewhere with the ESP.

+1 Danny Bacic over 2 years ago

TI__Mastermind 26736 points

Brandon,

Clemens is correct - this is purely a passive device, it does not have any integrated data processing. Am I understanding correctly that the half-baud operation is the problem? Or are you asking if operating at half baud is an issue for the SN65HVD230Q? For the latter, this is no issue. But for the former, unfortunately the transceiver would not be the cause of this clock-halving.... It would be software-related.

Best,

Danny

0 Brandon Van Pelt over 2 years ago

Prodigy 20 points

Thank you both for the answers, I am new to PCB development and just needed to confirm it was not something wrong with my hardware design.

0 Danny Bacic over 2 years ago in reply to Brandon Van Pelt

TI__Mastermind 26736 points

Brandon,

Of course, thanks for posting. Please continue to reach out on E2E if there are any items we can help with related to TI devices.

Best,

Danny

Interface

Interface forum

SN65HVD230Q: Running at half baud rate