DS90UB960-Q1: TI960/TI953 remote sensor physical I2C slave address programming

OH yu

Is below TI960 0x5D register programming a must? Instead of mapping the sensor slave address at TI960, can we map it with TI953 0x39 instead?

over 3 years ago

0 Hamzeh Jaradat over 3 years ago

TI__Guru** 115050 points

Hello OH,

If you do not want to use the slave ID or slave Alias, then you shall enable the "I2C PASS THROUGH ALL" bit in the DES (reg 0x58) so transactions not matching the DES/SER I2C address will be passed through to the SER I2C bus even if the address/alias registers are not set up.

0 OH yu over 3 years ago in reply to Hamzeh Jaradat

Prodigy 10 points

Hi Hamzeh Jaradat,

For passthrough all mode, how should ser be setup to intercept the I2C transaction for ser and sensor?

How about if we enable below bit and only with ser alias address setup but not the slave ID? If workable, how should ser be setup?

Thanks.

Best regards,

0 Hamzeh Jaradat over 3 years ago in reply to OH yu

TI__Guru** 115050 points

Hi OH,

you do not need to make any configuration changes on the SER.

0 OH yu over 3 years ago in reply to Hamzeh Jaradat

Prodigy 10 points

Hi Hamzeh Jaradat,

My questions were for de-serializer. What are the settings required for ser and des for cases below?

Case 1: passthrough all mode (0x58 bit 7)

Case 2: passthrough mode (0x58 bit 6)

Best regards,

0 OH yu over 3 years ago in reply to OH yu

Prodigy 10 points

Let me simplify the question. I would like to focus on case 2 (0x58 bit 6). Will below setup work or sufficient? Is DES slave_ID programming which I omitted below a must? I would like the slave ID translation to happen at SER side rather than at DES side.

DES setup: