• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 32 subscribers
  • Views 68 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DP83825I: Timing Requirement

noriyuki matuso
Prodigy 10 points
Part Number: DP83825I

Tool/software:

DP83825I has timing Requirement(T1, T2) in this below.

After masproduction, we noticed  that our productions didnt satisfy these timing requirement. 

If the ramp duration does not satisfy the minimum time 0.5ms, what problem occurs?

・Our T1, T2 are about 0.25ms.

・VDDA3V3 and VDDIO are same power source.

・After power uo, HW RESET_N is used.

  • 0
    TI__Mastermind 34395 points

    Hello,

    We do not have information for what happens out of these bounds as we have characterized the device per the specific parameters. Any deviation from the datasheet would place validation responsibility on customer. Off of the validation reports conducted, were there any problems being seen?

    Sincerely,

    Gerome