TUSB320LAI: App note SLYT822, How to implement an isolated usb 2.0 HS, Type-C DRP, error

Daniel Geue

Part Number: TUSB320LAI
Other Parts Discussed in Thread: ISOUSB211

Hi,

Just an FYI. Someone else may have noted this already but in Figure 4 (page4) of the app note SLYT822 (How to implement an isolated USB 2.0 high speed, Type-C® DRP), the image representation of the ISOUSB211 is incorrect. Pin6 should be VBUS2OK and pin 23 should be VBUS1OK.

Thanks,

Dan

4 months ago

0 Daniel Geue 4 months ago

Prodigy 70 points

also the text above the figure "It is possible to provide the VBUSOK1 output of the ISOUSB211 as input to the VBUS detect pin of the controller." should need to change as well.

0 Ryan Kitto 4 months ago in reply to Daniel Geue

TI__Guru 50605 points

Hi Daniel,

Noted, thanks for pointing this out. I will route this feedback to the team.

Thanks,

Ryan

0 Daniel Geue 4 months ago in reply to Ryan Kitto

Prodigy 70 points

Sounds good. Also document SLYT834 (Implementing an isolated USB 2.0 On-the-Go port) has the same image.

0 Ryan Kitto 4 months ago in reply to Daniel Geue

TI__Guru 50605 points

Hi Daniel,

Got it, thanks.

Thanks,

Ryan

Interface

Interface forum

TUSB320LAI: App note SLYT822, How to implement an isolated usb 2.0 HS, Type-C DRP, error