TPD4S009: connection of D+ and D-

K.Hamamoto

Guru 12155 points

Part Number: TPD4S009

Can I ask a simple question just in case?

There are some connection example on the datasheet.

Can IN- of differential input from external signal be connected to Dx+? (Another input (=IN+) can be connected to Dx-?)

I understand Dx+ and Dx- are connected each protection diodes. And we can refer fig 11 on the datasheet as I mentioned.

Regards,

Koji Hamamoto

over 7 years ago

0 Cameron Phillips over 7 years ago

TI__Genius 12410 points

Hello,

I assume you are asking if the Dx+ and Dx- lines can be swapped, yes they are the same circuitry on both sides. If that makes routing easier it is perfectly acceptable.

Regards,

Cameron

0 K.Hamamoto over 7 years ago in reply to Cameron Phillips

Guru 12155 points

Hi Cameron,

Thank you for your reply.

That is what I would like to ask. I understood.

Regards,

Koji Hamamoto

Interface

Interface forum

TPD4S009: connection of D+ and D-