SD303EVK: Driver won't install

Joe Brackett

Part Number: SD303EVK
Other Parts Discussed in Thread: LMH0318, LMH0397

I recently purchased this eval board and cannot get the drivers to install properly for it. I downloaded the launchpad SW from http://www.ti.com/tool/sd303evk and followed the instructions to update the driver after the installation and it cannot find the driver in the installed directory. I found the directory and see the NSCNanoUsb driver but when I try and update the driver to look for this it says "Windows could not find drivers for your device." Where can I find the correct driver for this eval board?

Thanks

Joe Brackett

over 6 years ago

0 Nasser Mohammadi over 6 years ago

TI__Guru* 93670 points

Hi Joe,
This SD303 board GUI was developed using win XP . Please confirm if you are using win xp.
Also, for new design, I would recommend either LMH0397 or LMH0318 - these are 3G cable driver with retiming function.
Regards,,nasser

0 Joe Brackett over 6 years ago in reply to Nasser Mohammadi

Prodigy 130 points

Hi
I am using Windows 10.

0 Nasser Mohammadi over 6 years ago in reply to Joe Brackett

TI__Guru* 93670 points

Hi Joe,
Could either LMH0397 or LMH0318 meet your requirements? GUI for these devices were developed using win 10. Additionally, these parts have onboard retimers as well.
Regards,,nasser

0 Joe Brackett over 6 years ago in reply to Nasser Mohammadi

Prodigy 130 points

Hi
Possibly, I would have to look into these parts. right now we have this eval board and really dont want to purchase another set.

0 Nasser Mohammadi over 6 years ago in reply to Joe Brackett

TI__Guru* 93670 points

Hi Joe,
Please take a look at these two parts to make sure they meet your requirements and which one would be a better choice for your application. Then we can look into your present SD303 and EVM for one of these two devices.
Regards,,nasser

Interface

Interface forum

SD303EVK: Driver won't install