LMH1981: Output Terminal Current

Hi Satoshi,

I found a description in datasheet

"Output Routing

The output signal paths should be routed using short, direct traces to minimize parasitic effects that may degrade

these high-speed logic signals. All output signals should have a resistive load of about 10 kΩ and capacitive load

of less than 10 pF, including parasitic capacitances for optimal signal quality. This is especially important for the

horizontal sync output, in which it is critical to minimize timing jitter. Each output can be protected by current

limiting with a small series resistor, like 100Ω."

Best Regards,

Shawn