• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 32 subscribers
  • Views 323 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DS110DF1610: About the data rate setting problem of DS110DF1610

Annie Liu
Genius 10295 points
Part Number: DS110DF1610
Other Parts Discussed in Thread: DS125DF1610, SIGCONARCHITECT

Hi Team,

According to the datasheet of ds110df1610, the customer is not sure which registers should be set for its divider settings. Is the 0x2f register a standard rate setting or a divider settings? When there is not a standard rate, what is the value of the parameter T of the Required PPM tolerance? Is it related to data rate?

Thanks.

  • 0
    TI__Guru* 93670 points

    Hi Annie,

    Please install SigconArchitect GUI and then DS125DF1610 profile. Run this GUI in demo mode and then go to the high level tab. Under high level tab, in CDR section you can enable manual mode to specify a data rate within the VCO range and a group divider setting. Once this is done, you can click on "Write Rate Regs" tab and it will show you contents of different register values. You can also go to the low level page to check on any register value.

    Regards,,nasser