Hi Team,
We would like to use TUSB320HAI for UFP in GPIO mode.
Then, we have four questions.
-----------
[Q1]
We understand that “The VBUS_DET pin must be connected through a 900kohm resistor to VBUS on the Type-C that is connected.”
However, we would like to use 910kohm (not 900kohm) because it is E24 series.
May I use 910kohm?
And, could you please let us know if you have any concern?
-----------
[Q2]
We don’t use INT_N/OUT3 and ID pins so these pins are OPEN.
Could you please let us know if you have any concern?
-----------
[Q3]
We use OUT1 and OUT2 pins and these pins are pulled up VDD by 100kohm.
Could you please let us know the your recommended pull up resistor value?
-----------
<Circuit Image>
Regards,
Hide
