SN65LVCP114: sn65lvcp114 application

Neal Zhu

Part Number: SN65LVCP114
Other Parts Discussed in Thread: DS100KR401, DS100KR800

The following is our application scenario. 10G data of SFP + is obtained through SN65LVCP114,Ethernet switching chips that pass through the backboard to the other single board,

10G KR mode is used for the back port, can it be used in this way?, thanks!

over 3 years ago

0 Nasser Mohammadi over 3 years ago

TI__Guru* 93670 points

Hi Neal,

SN65LVCP114, DS100KR401, DS100KR800, or other linear redrivers can be used for KR applications.

Regards,, Nasser

0 Neal Zhu over 3 years ago in reply to Nasser Mohammadi

Expert 2470 points

Hi，

The CIN/COUT of SN65LVCP114 is connected with SFP+,between is the SFI interface,

SFI mode is used for C port and KR mode is used for A/B port. Can it be applied in this way?

Is there a need for intermediate interface conversion devices?

thanks！

0 Nasser Mohammadi over 3 years ago in reply to Neal Zhu

TI__Guru* 93670 points

Hi Neal,

I believe this should be fine. LVCP114 is a linear redriver and duplicates or replicates the input to the best of its linearity. Please note figure 34 of the data sheet. In this example, 14Gbps NRZ BERT signal is used.

Regards ,, Nasser

0 Neal Zhu over 3 years ago in reply to Nasser Mohammadi

Expert 2470 points

SN65LVCP114, at a rate of 10.3125Gbps, FR4 sheet,

How many inches can we transfer to?

how much dB can I compensate for?

Thanks!

0 Nasser Mohammadi over 3 years ago in reply to Neal Zhu

TI__Guru* 93670 points

Hi Neal,

SN65LVCP114 gain is optimized for 14Gbps or 7GHz nyquist. At 10.3125Gbps gain would be lower than what is noted in table 3 by about 1 to 2dB.

Regards,, Nasser

Interface

Interface forum

SN65LVCP114: sn65lvcp114 application