• State Resolved
  • Locked Locked
  • Replies 5 replies
  • Answers 2 answers
  • Subscribers 15 subscribers
  • Views 357 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

ISO3082: Change point from Revision I to J

R.Fukunaga
Expert 1665 points
Part Number: ISO3082
Other Parts Discussed in Thread: ISO3086, ISO3080

Hi all,

I would like to know change point of the device from Revision I to Revision J.

It says that the temperature, electrical, and switching characteristics have changed.

How many did the value change from before to after the change?

If you have a comparison table, please let me know.

Best Regards,

Ryusuke

  • 0
    TI__Expert 8030 points

    Hi Ryusuke,

    Thanks for reaching out. We are currently looking into this, and will get back to you within the next 24 hours.

    Regards,

    Kenneth

  • 0 in reply to Kenneth Arnold
    TI__Expert 8030 points

    Hi Ryusuke-san,

    Here is revision I of the ISO3082 datasheet: 

    ISO308x_Revision_I.pdf

    You can use this previous revision of the datasheet to see which exact specifications were changed from revision I to revision J.

    Regards,

    Kenneth

  • +1 in reply to Kenneth Arnold
    TI__Expert 8030 points

    Hi Ryusuke-san 

    I went through each of the electrical, temperature, and switching specifications for each of the datasheets and found the following changes:

    -The absolute maximum rating specification for the voltage input at any D, DE or RE terminal changed from 7 V to 6 V

    -The junction-to-ambient thermal resistance specification was changed to have a single specification of 79.6 C°/W

    -The VDE section of the safety-related certifications table was changed to reflect the latest standard

    -The differential input capacitance of the receiver was changed from 7 pF to 16 pF

    -The input capacitance to ground specification of the receiver was changed from 2 pF to 8 pF

    -The specification for the maximum pulse width distortion of the ISO3086/88 driver was changed from 7.5 ns to 9 ns

    -An additional specification for the pulse width distortion of the ISO3080/82 receiver was added

    -A differential output rise and fall time specification for the receiver was added

    If you have any further questions about changes to any of the other electrical, temperature, and switching specifications, please let me know.

    Regards,

    Kenneth

  • 0 in reply to Kenneth Arnold
    Expert 1665 points

    Hi Kenneth,

    Thank you for your help.

    Regards,

    Ryusuke

  • 0 in reply to R.Fukunaga
    TI__Expert 8030 points

    Hi Ryusuke-san,

    Thanks for the update. If you have any further questions, please let me know.

    Regards,

    Kenneth