• State TI Thinks Resolved
  • Locked Locked
  • Replies 4 replies
  • Answers 2 answers
  • Subscribers 15 subscribers
  • Views 1240 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

ISO7740: Recommendations for alternatives

Yuxi Liu(Tony)
Expert 4540 points

Part Number: ISO7740
Other Parts Discussed in Thread: ISOM8110, ISOM8711, ISOM8710, ISO8110

Tool/software:

Hi TIer

Could you help me find the below ISO chip good alternatives?

Thank you very much.

H11L1(Onsenmi ):

EL2501-G(EVERLIGHT):

6N137SD(Onsenmi ) : ISO7740?

  • 0
    Guru 327330 points

    There are no P2P replacements for these devices.

    The EL2501 is a phototransistor optocoupler; the ISOM8110 has the same electrical characteristics, but in an SMD package.

    The ISOM8711 is designed as a direct replacement for the HCPL-M600/611, which is the 5-pin version of the 6N137.

    The H11L1 is a 1 Mbps device; the ISOM8711 is faster and has a different package and pinout.

    The ISOM devices emulate a LED input. If you can change the circuit so that you have two power supplies and single-ended signal inputs, then you can use any ISO isolator.

  • 0 in reply to Clemens Ladisch
    TI__Mastermind 34580 points

    Hello Tony,

    As Clemens stated, we do not have direct package compatible opto-emulators. 

    ISOM8710 is the closest functionally to H11L1 and 6N137SD, and ISO8110 is the closest to EL2501-G. The opto-emulators will have faster data rate and bandwidth than the traditional optocouplers. 

    ISO7740 and digital isolators are preferred for digital signals due to higher channel density, improved isolation, and faster data rates. However, this would require a redesign of the PCB an isolated power supply. 

    Best,
    Andrew

  • 0 in reply to Andrew J
    TI__Expert 4540 points

    Hi Andrew and Clemens

    Thank you for your reply.

    My customer EE is Medical Patient monitor.

    Due to the existence of medical standards, the customer actually needs an isolation level of >5kV .

    Since the customer has already created an isolated power supply based on a fly-back topology, isolated power supply is not an issue .

    Reference this E2E link:Our opto-coupled emulators don't seem to have a higher isolation level.

    https://e2e.ti.com/support/isolation-group/isolation/f/isolation-forum/1387822/isom8110-wider-package-requirements/5306246#5306246

    H11L1(Onsenmi ):ISOM8710 ,ISOM8711 

    EL2501-G(EVERLIGHT):ISOM8110 

    6N137SD(Onsenmi ) :ISOM8710  ISO7740

    PC817: ISOM8110

    So , Optocoupler emulator cannot be used in this socket.

    Are there any other good ideas?

    Thank you very much

  • 0 in reply to Yuxi Liu(Tony)
    TI__Mastermind 34580 points

    Hello Tony,

    I will follow up with you offline for specific details on this opportunity. 

    As of today, TI uses digital isolators to support >5kV isolation. 

    Best,
    Andrew