• State TI Thinks Resolved
  • Locked Locked
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 13 subscribers
  • Views 561 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Original question:

ISOW7842: Latch-up?

ISOW7842: Latch-up issue

Peter Tseng
Mastermind 6240 points
Part Number: ISOW7842


Dear Sir,

About the old post, may I know did the issue fixed or not since the last post mentioned you will go by mail and post again if issue address.

https://e2e.ti.com/support/isolation/f/1013/t/769224

Thanks.

  • 0
    TI__Guru 55815 points

    Hi Peter,

    The necessary suggestions (also mentioned in section 11 of of ISOW7842 datasheet) to avoid such an issue were provided to customer.

    Do you see any issues in using ISOW or was it a general question?

    Regards,
    Koteshwar Rao

  • 0 in reply to Koteshwar Rao
    Mastermind 6240 points

    Hi sir,

    It is the general question.

    Customer want to use ISOW7842, but he saw there were some issue discussion on E2E but no any answer for them.

    They want to double-check again.

    Thanks.

  • 0 in reply to Peter Tseng
    TI__Guru 55815 points

    Hi Peter,

    Thanks for the confirmation. We don't expect any specific issue with ISOW7842, it being an isolated DC/DC converter it will have similar benefits and challenges like any other isolated DC/DC converter.

    I will go ahead and close this post but if you do have any further questions, you can reply back or create a new post. Thanks.

    Regards,
    Koteshwar Rao