Tiva_DK_TM4C129 with BDI.

Jam Akh

I want to connect Tiva_DK_TM4C129 with BDI.Is there any connector that can connect DK with BDI?

Thanks

0 Amit Ashara over 11 years ago

Hi Jam,

Which BDI hardware model is it? Also did you check if it supports Cortex M4? What is the Debugger SW are you planning to use, IAR, CCS, etc?

Amit

0 Jam Akh over 11 years ago in reply to Amit Ashara

Hi,

I am using BDI3000..I think it supports Cortex M4..

0 Amit Ashara over 11 years ago in reply to Jam Akh

Hi Jam,

You may need to check for the correct target cables.

http://www.abatron.ch/fileadmin/user_upload/products/pdf/PL-Spare-BDI3000.pdf

Also please check the User Guide for DKTM4C129 for mating connector.

I am expecting on the GNU Debugger part that someone more knowledgeable would be able to tell what needs to be done

Regards,

Amit

0 Jam Akh over 11 years ago in reply to Amit Ashara

Hi,

Yes I have therse cables with me but on the board there is half size 20 pin connector and there is no such BDI cable to connect to board.

0 Amit Ashara over 11 years ago in reply to Jam Akh

Hi Jam,

You may want to check Product Code 90085

For Cortex based target systems with the 10-pin or 20-pin 0.05'' Samtec FTSH connector as

defined by ARM

Amit

Arm-based microcontrollers forum