Determining TM4C123 silicon revision

Engin Bilgin

Hello Forum,

I am trying to determine the silicon revison of the chips I have to see if any of the errors listed in the errata document apply to my case. However no revison number is indicated as part of the on-chip markings as shown below

"980 YF

TM4C123G

H6PMI

58AJF7W

G4"

What does it mean when revision is not indicated, that the silicon is error free?

Regards,

Engin

over 9 years ago

0 Amit Ashara over 9 years ago

TI__Guru**** 244440 points

Hello Engin

Looking at the marking it is RA1 silicon.

Regards
Amit

0 Engin Bilgin over 9 years ago in reply to Amit Ashara

Prodigy 80 points

Hello Amit,
Does this mean the list errors listed in the SPMZ849F.pdf document does not apply to the parts I have? (My parts being RA1 and the affected revision 6 and 7 silicones being RB1 and RB2 according to Table 1 in the said document?) Sorry to bother you but I could not find an errata document for previous versions.
Regards,
Engin

0 Amit Ashara over 9 years ago in reply to Engin Bilgin

TI__Guru**** 244440 points

Hello Engin

Apologies. Being a little sloopy this morning. I should have written B1 silicon instead of A1 silicon

Regards
Amit

Arm-based microcontrollers

Arm-based microcontrollers forum

Determining TM4C123 silicon revision