DRV8301-HC-C2-KIT: XDS100 Driver not recognized in Device manager

Hi Abhay,

I am having your forum post re routed to the appropriate JTAG expert. In the meantime, please checkout this JTAG connectivity debugging document.

https://www.ti.com/lit/spracf0

Regards,

Ozino

Hi Abhay,

Please run CCS installer and select the XDS100 class probes during the installation setup. The CCS installation will then install the drivers.

Thanks,
Ashwini

Thanks Ashwini.

Yes. The drivers automatically got installed while installing CCS.

I had second problem where my insta spin bldc UI was not detecting board. But this also worked out as I powered the board with 20V external source.

Earlier, the boards which I used to get detected just by usb power.

Now I have 3rd problem, when I try to upload default programs using CCS software say, insta spin sensorless, my board is still not getting detected. And it shows an error no. 1135 for connection.

I contacted customer care n they said to erase the flash program n try connecting again.

Would appreciate any support in this.

Thank you

Thanks Ozino for support.

Hi Abhay,

Please could you post the full error message as it appears in CCS?

Thanks,
Ashwini