TMS320F28027F: launchXL-F28027F +DR8305

huajing hu

Part Number: TMS320F28027F
Other Parts Discussed in Thread: LAUNCHXL-F28027F, , CONTROLSUITE

Hi, I would like to change the launchXL-F28027F +DR8305 development kit solution to TMS320F28027F+ single op amp +IPM module to control PMSM.Do you have any information about the changes in this respect? What changes should be made to the supporting procedures?thank you

over 4 years ago

0 Yanming Luo over 4 years ago

TI__Guru** 117270 points

Please take a look at chapter 5.2 (Hardware Prerequisites) and 4.1 (Currents and Voltages) of InstaSPIN-FOC and InstaSPIN-MOTION User's Guide ( https://www.ti.com/lit/spruhj1) that have a detailed description of these. Design the current and voltage sensing according to your motor, and select the 3 EPWM modules and connect the outputs to the power module.

Also you might refer to the High voltage Kit as the link below

http://www.ti.com/tool/tmdshvmtrinspin

And find the design file for this kit as the folder below after installed the controlSUITE

CONTROLSUITE
http://www.ti.com/tool/CONTROLSUITE

C:\ti\controlSUITE\development_kits\HVMotorCtrl+PfcKit_v2.1\~HVMotorCtrl+PFC-HWdevPkg

0 huajing hu over 4 years ago in reply to Yanming Luo

Prodigy 25 points

OK,Thank you!

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMS320F28027F: launchXL-F28027F +DR8305