TMS320F280049C: Problem with load program in flash and the procedure after power on

Johnny Chen

Part Number: TMS320F280049C

Hi Champ,

I am asking for my customer.

Currently, they are using XDS100v2 to load program in flash.

After power off, then power on again, the program does not appear to be RUN.

However, the program is loaded already. What might be the reason ?

Also, may I confirm the standard procedure of load program in flash after power on again ?

Thanks for any support.

Best regard.

+1 Vamsi Gudivada over 4 years ago

Johnny,

Are the boot mode pins configured for flash boot? If not, try that.

Thanks and regards,
Vamsi

0 Johnny Chen over 4 years ago in reply to Vamsi Gudivada

Hi Vamsi,

I have look throughly to the customer's code. It is wrong with the BEGIN address in .cmd file.

Thanks for your help.

Best regard.

0 Vamsi Gudivada over 4 years ago in reply to Johnny Chen

Johnny,

Glad it is resolved now. I will close this post.

Thanks and regards,

Vamsi

C2000 microcontrollers forum