TMS320F28069M:

Nathan Parkinson

Part Number: TMS320F28069M
Other Parts Discussed in Thread: LAUNCHXL-F28069M

Hello.

I'm having issues testing the connection after setting up the target configurations for my F28069M. After selecting the XDS100v2 connection and my associated board, I have tried to test the connection only for it to respond with a failed test. The com port I am using is recognized, so I believe my XDS100v2 connection is working properly, however I have not been able to determine where my error is.

Thanks

over 4 years ago

0 Santosh Jha over 4 years ago

TI__Guru 50611 points

Nathan,

Is this custom board or TI EVM? Please open the target configuration and run the "Test Connection". It should report the error code for the failure. Search the error code in the following page. It will explain what is the error and how to resolve.

https://software-dl.ti.com/ccs/esd/documents/ccs_debugging_jtag_connectivity_issues.html

0 Nathan Parkinson over 4 years ago in reply to Santosh Jha

Prodigy 30 points

I searched the document for similar error codes and have only found results for a possible cable connection issue, which is not the case. Here is an image of the test connection error message.

+1 Chester Gillon over 4 years ago in reply to Nathan Parkinson

Guru 92251 points

Nathan Parkinson said:
Here is an image of the test connection error message.

If you are using a LAUNCHXL-F28069M, see XDS100v2 USB Debug Probe Failed 'Test Connection' on LAUNCHXL-F28069M for a potential cause of those errors.

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMS320F28069M: