TMDSCNCD280039C: TMDSCNCD280039C control board debug issue

Bharat Chauhan

Prodigy 220 points

Part Number: TMDSCNCD280039C
Other Parts Discussed in Thread: C2000WARE

Hello Sir,

I am using TMDSCNCD280039C development board for my project development.

I am facing issue with debugging after loading the software in controller.

Error = No source available for "_system_post_cinit()

I have attached snapshot for your reference.

over 3 years ago

0 Veena Kamath over 3 years ago

TI__Mastermind 32655 points

Hi Bharat,

This probably means there has been a reset and the PC is stuck somewhere in boot sequence. Is this an example from C2000ware. If not, can you try loading an example from C2000ware?

Regards,

Veena

0 Bharat Chauhan over 3 years ago

Prodigy 220 points

Hello,

With C2000ware example its working fine but with my project its showing error.

I want to know how to resolve this problem in my project???? What is the reason for showing this kind of error??

Regards,

Bharat

0 Veena Kamath over 3 years ago in reply to Bharat Chauhan

TI__Mastermind 32655 points

Hi Bharat,

You need to figure out what is causing the reset. After loading, does it reach main? It is also good to check the Memory Error registers to see if any error flags are set

Regards,

Veena

+1 Veena Kamath over 3 years ago in reply to Veena Kamath

TI__Mastermind 32655 points

Hi Bharat,

Since we haven't heard from you for the last few weeks, we assume the issue has been resolved. I am closing this thread. In case the issue is not resolved, please reject the resolution and let us the know the status to help further.

Regards,

Veena

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMDSCNCD280039C: TMDSCNCD280039C control board debug issue