TMS320F28379D: SysConfig update

BRUNO LEFEBVRE

Prodigy 140 points

Part Number: TMS320F28379D
Other Parts Discussed in Thread: SYSCONFIG

Hello,

Trying to run "epwm_ex1_trip_zone" example, I got the following message when building the project :

"Error: C2000 SysConfig version 3.01.00.00 requires at least version 1.10.0 of SysConfig"

My current installed version of SysConfig is 1.11.0, the last one found on the web.

Therefor, I don't understand what to do.

Can anybody help me ?

Many thanks in advance.

over 3 years ago

0 Nima Eskandari over 3 years ago

TI__Guru 52040 points

Is CCS picking up the latest version of sysconfig you installed? Can you check the CCS windows/preferences page?

0 BRUNO LEFEBVRE over 3 years ago in reply to Nima Eskandari

Prodigy 140 points

Dear Nima,

I think so, yes,

You can see below a picture of my config CCS :

Bruno

0 Nima Eskandari over 3 years ago in reply to BRUNO LEFEBVRE

TI__Guru 52040 points

You get the error when you double click and try to open the .syscfg file?

0 BRUNO LEFEBVRE over 3 years ago in reply to Nima Eskandari

Prodigy 140 points

Yes, I get the error following both operations

- Either I double-click on .syscfg file

- Or I build the project.

0 Nima Eskandari over 3 years ago in reply to BRUNO LEFEBVRE

TI__Guru 52040 points

You clearly have 1.11 installed. In the command line, when the compile occurs, if you do a full "REBUILD" of the project, the first instruction will be to the sysconfig_cli. What is the path of the sysconfig_cli you see in the command line log?

0 BRUNO LEFEBVRE over 3 years ago in reply to Nima Eskandari

Prodigy 140 points

You are right, he is invoking a wrong version

The 1.11 version is stored on : C:\ti\sysconfig_1.11.0

Could you indicate which property option needs to be modified ?

0 Nima Eskandari over 3 years ago in reply to BRUNO LEFEBVRE

TI__Guru 52040 points

Well my understanding was that when the products in CCS show SysConfig 1.11, that's what would be used.

Darian Sale can you help with why the new SysConfig tool version not picked?

0 Darian Sale over 3 years ago in reply to Nima Eskandari

TI__Expert 5985 points

I believe that while CCS has discovered the new version, it's not using that version for your project. Right click on the project and select "properties", then on the "general" node click on the "products" tab

From there, click "add" and select SysConfig and the version. That should cause this one project to use the newer version of SysConfig

0 BRUNO LEFEBVRE over 3 years ago in reply to Darian Sale

Prodigy 140 points

Dear Nima, Dear Darian,

Thanks a lot for your advice.

It works finally !! that's ok now.

Bruno

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMS320F28379D: SysConfig update