• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 82 subscribers
  • Views 364 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TIDM-HV-1PH-DCAC: TIDM-HV-1PH-DCAC

Najmeh Nourieh
Prodigy 30 points

Part Number: TIDM-HV-1PH-DCAC

Hi, 

I tried to work with the this module, but each time that I want to turn it on I need to run the program, set rlyConnect to 1, then the board starts to work. Is any solution to not have connection between the board and laptop and turn the board on? 

Regards,

Najmeh

  • 0
    TI__Genius 11985 points

    You need to setup the jumper on the MCU control card so that the program will run in standalone mode. Please check the User-Guide and the MCU control card documentation for jumper setting for stand-alone mode operation. You also need to make sure you use the on-board power supply (there is a +12V output isolated power supply board with the h/w set-up) for supplying all the low voltage power to the board when the HV DC input is applied.

    Shamim