Part Number: TMS320F28377S
hello,
As shown in the figure above, when OTPkey is not equal to 0X5A, it boots to flash, but why watchdog is enable.
Now I have a problem that the program will always run in copy_ decompress_ lzss. c, the main function cannot be entered. Is this problem related to the watchdog?
Thank you for your reply: I found that when the program runs to 0x850e2 (_TI_auto_init), it will return to 0x80000 instead of calling the main function when I use the disassembly step-by-step debugging. So I suspect a reset caused by triggering WD while initializing global variables. I disabled WD in CoderStartBranch.asm, and the program can jump to main normally； As shown in the picture below (is it correct to close WD in this way?). Is it possible to change the period of WD during boot?
