TMS320F28386S: Controlling flash erase during build

John Hite

Part Number: TMS320F28386S
Other Parts Discussed in Thread: UNIFLASH

There is a selection for On-Chip Flash under tools and I have used it to control flash erase during builds. Is there any other way to control which areas of flash are erased during a build?

Thanks,

John

over 3 years ago

+1 Santosh Jha over 3 years ago

TI__Guru 50611 points

John,

You can also use uniflash tool.

https://www.ti.com/tool/UNIFLASH

It is mentioned in f2838x product page.

https://www.ti.com/product/TMS320F28388D#software-development

Regards, Santosh

0 John Hite over 3 years ago in reply to Santosh Jha

Expert 1355 points

Thanks Santosh.

As is often the case I did not do a good job of presenting my question. What I meant to ask is whether there was a way to control it as part of the build process. But actually I see no reason to erase all blocks as a default. So I will just leave it set to erase as needed unless there is a problem.

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMS320F28386S: Controlling flash erase during build