controlSUITE pcb sch files

Zhelu guo

Other Parts Discussed in Thread: CONTROLSUITE, DXP, TMDSADAP180TO100

Dear TI-Team

Hello ,the controlSUITE(about motor control) of your company is very comvenient , it help me improve my efficiency since i know it. But I want to open the .pcb and .sch files of the develep kits in the installation directory. I have tried cadence16.3. pads9.3 and dxp 2009 winter , but I can not open them .Can you tell me which sofeware I should use to open them ? thank u.

Guo Zhelu

2011.08.24

over 14 years ago

0 Brett Larimore over 14 years ago

TI__Guru 57255 points

Guo,

The schematic and pcb files open with ExpressPCB, a freeware schematic tool:
http://www.expresspcb.com/ExpressPCBHtm/Download.htm

Unfortunately, these files don't translate into any of the more mainstream board design suites.

Thank you,
Brett

0 Christian Tacke over 10 years ago in reply to Brett Larimore

Prodigy 10 points

Hi,

i tried that software with controlCARDs/Hardware Starter Module/180-to-100 Pin Card Adapter, but I was told that the files are not valid. Is a specific version needed?

Greetings,
Christian T

0 Gautam Iyer over 10 years ago in reply to Christian Tacke

Guru 192875 points

Chris,

Not all have been developed by same software. Hence you're unable to open the above schematics. Few are compatible with EAGLE, few with Mentor Graphics.

Regards,
Gautam

0 Brett Larimore over 10 years ago in reply to Gautam Iyer

TI__Guru 57255 points

Gautam is correct. In particular, the TMDSADAP180TO100 was done in Mentor PADS.

Thank you,
Brett

C2000™︎ microcontrollers

C2000 microcontrollers forum

controlSUITE pcb sch files