• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 82 subscribers
  • Views 484 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

ACI3-3

Fizatul Aini Patakor
Prodigy 10 points
Other Parts Discussed in Thread: TMS320F2812, CONTROLSUITE

I use DMC1500 and DSP TMS320F2812 and use incremental System Bulid Block. I have stuck in Phase 2, since did not generate phase-a current and phase-b current, in CCS graph and even in PWMDAC. Please advice, if there is something to be done on setting.

Regards

Fiza

  • 0
    TI__Guru** 119670 points

    unfortunately we are not able to support this older HW and SW any longer. We are using TMDSHVMTRPFCKIT and solutions inside of controlSUITE

    however, for your board it seems like you are stuck on sampling the system.  I would check the voltage and current measurements, make sure you are sampling valid values.