TMS320F28P650DK: CLB Tile Counter Reset

Hello,

This seems to be an issue with the simulation software, on hardware the reset signal is active high. I will look into getting this issue fixed in the CLB simulation tool.

Thank you,

Luke

Thanks for your reponse, I will wait for the fixed version.

I will provide an update once I identify the cause of this issue.

Hi, Luke.

    Have you already fixed this question?

Hi Songmingbo,

Could you try altering the following file:

C:\ti\c2000\C2000Ware_5_02_00_00\utilities\clb_tool\clb_syscfg\systemc\src\CLB_counter_SC_model.cpp

Try changing the following line:

Hi, Luke.

    I have already modifed the code like bellowing according to your suggestion, which is indicated in the Figure. 1. Then I do the CLB simulation again, but I found that the result that is indicated in the Figure. 2 still not correct. Please help me to fix this problem, thanks.

Figure. 1

Figure. 2

Hi Songmingo,

I have reached out to our CLB software expert to find out if there is some way to recompile the .cpp file so that the updated code reflects the behavior in simulation. I will get back to you once I receive a response.

Thank you,

Luke

Hi, Luke.

    Thanks for your timely response. Wait for your good news. 

Hi Songmingo,

I heard back from our software expert, they are currently looking into this issue.

Thank you,

Luke

Hi, Luke.

Thanks for feedback this problem to your team. Have you already received useful response from your CLB software team?

Hi Songmingo,

The software team responded back, they will provide an update next week.

Thank you,

Luke

Hi, Luke.

Have a good new week. Have you already got the update from your team? I'm really looking forward to it.

Hi Songmingbo,

The software team should respond some time this week. I'll keep you updated.

Thank you,

Luke

Hi, Luke.

Have your team already fixed this problem? I'm looking forward to your reply. : )

Best regards.

Mingbo Song

Hi Mingbo,

The software team responded back yesterday, they are still working on this. Apologies for the delay.

Thank you,

Luke