Because of the holidays, TI E2E™ design support forum responses will be delayed from Dec. 25 through Jan. 2. Thank you for your patience.

  • State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 82 subscribers
  • Views 73 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TMS320F28034: AQCSFRC shadow mode effect timing.

Hang Yang
Intellectual 1781 points
Part Number: TMS320F28034

Tool/software:

Hi experts,

My customer is using two AQ, AQCSFRC (shadow to active when CTR=0) set high and CTR=0 set low.

These two AQ event occurs at the same time and the TRM says:

"The general rule is events occurring later in time have a higher priority and software forced events always have the highest priority"

does it mean that the two events happens one after another? Customer is observing a spike at CTR=0, would it results form a CTR=0 set low right after software set high?

Regards,

Hang.

  • 0
    TI__Mastermind 21180 points

    Hi Hang,

    The continuous software force always takes priority regardless of whether it happens before or after other action qualifier events. You may observe a spike in the output if an action qualifier event happens immediately before a continuous software force event.

    To clarify, you're saying the TBCTR=0 event sets the output low and the continuous software force sets the output high? Are there any other action qualifier events that set the output high? Can you provide a screenshot of the spike?

    Thank you,

    Luke