TMS320F28P650SH：TMS320F28P650SH

? ?

Part Number: TMS320F28P650SH
Other Parts Discussed in Thread: SYSCONFIG, C2000WARE

Tool/software:

If no input is selected for this boundary input, does it mean that the input used for this boundary is the clb input set above.

Or how can I choose the non analog input of CLB

over 1 year ago

0 Luke Jones over 1 year ago

TI__Mastermind 28580 points

Hello,

The boundary inputs menu you're referring to is only used by the CLB simulator tool. To configure the actual inputs to the CLB, you should do this in the CLB menu of SysConfig and add an Input:

Thank you,

Luke

0 ? ? over 1 year ago in reply to Luke Jones

Prodigy 40 points

That's not what I meant. How can I choose this CLB non analog input in LUT

0 Allison Nguyen over 1 year ago in reply to ? ?

TI__Mastermind 27500 points

Hello,

This expert is currently out of office until 10/21, so please expect a delay in response before then. Thank you for your patience.

I also wanted to refer you to the CLB Tool User's Guide in the meantime in case it helps: https://www.ti.com/lit/ug/spruir8b/spruir8b.pdf

Best Regards,

Allison

0 Luke Jones over 1 year ago in reply to Allison Nguyen

TI__Mastermind 28580 points

Hello,

You should select boundary input 0 to 7 as you have shown in your latest post. To configure these boundary inputs, you should do this in the CLB menu, not the TILE menu. You must add an input 0-7 as I showed in the screenshot in my previous post. Let me know if this is clear.

Thank you,

Luke

0 ? ? over 1 year ago in reply to Luke Jones

Prodigy 40 points

I have already added the input in clb, but I am not sure how to select this input from clb in LUT

0 Luke Jones over 1 year ago in reply to ? ?

TI__Mastermind 28580 points

To select the input in the LUT you need to select boundary input x in the dropdown for the LUT menu and then enter the correct logic equation such as:

"i0" OR

"i0 & i1"

depending on what logic you want to implement.

Thank you,

Luke

0 ? ? over 1 year ago in reply to Luke Jones

Prodigy 40 points

thanks，then

When I configure clb in an existing project, the following error occurs during compilation, which may be caused by inconsistent naming of. h files. Is there any solution

0 Luke Jones over 1 year ago in reply to ? ?

TI__Mastermind 28580 points

This might be due to incorrect include paths. Did you start from a C2000Ware example?

Thank you,

Luke

0 ? ? over 1 year ago in reply to Luke Jones

Prodigy 40 points

NO，not start from a C2000Ware example

0 Luke Jones over 1 year ago in reply to ? ?

TI__Mastermind 28580 points

You didn't start from an empty example? If not can you describe the process you followed for creating a CCS projects and including the correct files?

Thank you,

Luke

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMS320F28P650SH：TMS320F28P650SH