TMS320F28021: How to read data and write on other mcu

Hi Zubair,

In CCS you can perform a memory dump of the Flash memory. In the CCS "View" option, select from the dropdown the "Memory" tab. 

There should be an arrow next to the "Format" dialog box to export the memory, where an "Export Data" dialog box will be shown. 

You should then provide a file name, file format and Address for starting memory range w/ Length in words. 

Once ready, click ok to save your data to your generated file. You can then load this data through CCS/Uniflash for the next device you have.

Thanks and regards,

Charles

Thanks for reply, i just connected my xds100v3 and open ccs. in view option i just press memory. that dosnt showing anything and just asking address. no dialog box is appearing. 

and how to start with device first? what device have to select? 

Hi Zuhair,

Are you using the latest version of CCS? 

To start with device first, you have to generate a CCXML file for your device F28021 and use XDS100v3 connector as the connection type. Once this file has been generated, you can start a Project-Less Debug to connect to the device. 

Thanks and regards,

Charles

yes, i am using latest version of CCS and i do have CCXML file for TMS320F28021. what do next? i open CCXML file and test connection. it shows success, after i go to memory for reading, i write main in location, it shows no active debug session. kindly guide