TMS320F280039C-Q1: How to realize SR Flip-flop and SR Latch using CLB?

Could I use the SR Latch?/Flip-flop? in the figure above to realize the SR Latch and the SR Flip-flop??? one signal is from EPWM1A and another signal is from an outside input of my board

Please refer to this thread:

https://e2e.ti.com/support/microcontrollers/c2000-microcontrollers-group/c2000/f/c2000-microcontrollers-forum/913165/tms320f280049-realizing-flip-flops-with-clb?tisearch=e2e-sitesearch&keymatch=CLB%2520SR%2520flip%2520flop#

Hi Lori,

I've already read this article, and my question is indeed based on this thread.

Thanks & B/R

Jankel

Jankel Cao said:

Could I use the SR Latch?/Flip-flop? in the figure above to realize the SR Latch and the SR Flip-flop??? one signal is from EPWM1A and another signal is from an outside input of my board

If you only need one of the options (set/clear/delay) then the AOC block can be used. 

yes i've already tried, but I found AOC block can only realize the asynchronous set/clear right? it cannot realize synchronous SET or CLR?