• State
  • Replies 2 replies
  • Subscribers 83 subscribers
  • Views 62 views
  • Users 0 members are here
Support feedback
Options
Options
Related

Original question:

LAUNCHXL-F28P65X: Which CCS version last included the C28x/F2833x software simulator?

LAUNCHXL-F28P65X: JP1 Connector broken with Pad

Alekya Reddy Pinninti
Prodigy 50 points

Part Number: LAUNCHXL-F28P65X

Hello,

Greetings!!!

I am using LAUNCHXL-F28P65X and JP1 connector is broken with pads for the launchpad.

How to fix the issue incase of Broken JP1?

Please give the workaround in detailed as we were unable to connect to Launchpad due to above issue.

image.png

 

Regards,
Alekya Reddy

  • 0
    TI__Expert 7910 points

    Hi,

    I will take a look and reply in timely manner.

  • 0 in reply to Stevan Duraskovic
    TI__Mastermind 25031 points

    Hi Alekya,

    You have two options. JP1 bridges the isolation between the debugger side of the board and the MCU side of the board. If you wish use non-isolated power, then you can solder a wire vertically across the isolation barrier, one for power and one for ground. Then the board can be powered by USB connection.

    If you want to only use isolation, then even if the JP1 is broken you do not need to alter the board. You can plug in the USB cable to provide power to the debugger. Then power the MCU portion of the board using a separate power supply. Either 3.3V and keep only J17 connected and J16 disconnected. Or 5V input and keep J16 connected and J17 disconnected. The power can be supplied at any of the 3.3V or 5V locations on the boosterpack pins

    Regards,

    Peter